- Hewlett-Packard SAN Switch Installation Guide

3. At the Fabric Parameters prompt, enter y and press Enter:

Fabric Parameters (yes, y, no, n): (no) y

4. Enter a unique domain ID, such as the domain ID used by the previous switch, if

it is still available:

Domain: (1..239) [1] 3

5. Respond to the remaining prompts or press Ctrl+D to accept the default settings.

6. Issue the switchenable command to re-enable the switch.

7. Optional: Specify any custom status policies:

a. Issue the switchstatuspolicyset command. This command sets the

policy parameters that determine the overall switch status.

b. Customize the status polic ies.

To deactiva te the alarm for a particular policy, enter 0 at the prompt for that p olicy.

InstalltheSFPtransceivers

The SAN Switch does not ship with SFPs. For a list of supported SFPs, see Table

2 on page 33.

The ports sele

cted for use in trunking groups must meet specific requirements. For a l ist of

these requirements, see the ISL Trunking chapter in the Fabric OS administrator’s guide.

To install the SFP transceivers:

1. Position the

transceiver so that it i s oriented correctly and insert it into a port until the

latching mechanism clicks. The transceivers are keyed to ensure corre ct orientation.

If the tra nsceiver does not install easily, make s ure it is oriented correctly.

For instructions specific to the transceiver you are using, see the transceiver

manufacturer’s documentation.

2. Repeat ste

p1for the remaining ports, as required.

SA N Switch installation guide