- Hewlett-Packard SAN Switch Installation Guide

4. When the terminal emulator application, which uses a serial connection, stops
reporting information, press Enter to display the login prompt.
5. Log in using the administrative account; the logon is admin and the default
password is password. Create up to two simultaneous admin sessions and four
user sessions.
For more details, see the Fabric OS administrator’s guide and the Fabric OS
command reference manual for the Fabric OS ru nning on your switch.
Set the IP address
By default, the
IP address is set to 10.77.77.77. To replace the default IP addressing
information w
ith the informa tion provided by your network administrator:
1. Enter ipaddrset at the terminal emulator application prompt.
2. Enter the IP addressing information, as prompted.
3. Optional: Verify that the address is correct by issuing the ipaddrshow command
at the promp
t.
4. Record the IP address on the label located on the por t side of the chassis.
For the 4/32, 4/32B and 4/64 SAN Switches, record the IP address on the
pull-out t
ab on the port side of the switch. See Figure 2, Figure 7 or Figure 4)to
locate the pull-out tabs.
5. If the serial port is no longer required, log out of the seria l console, remove the serial
cable, and replace the safety plug in the serial port.
SA N Switch installation guide
57