- Hewlett-Packard SAN Switch Installation Guide

Figure 14 Assemb ling the out er rails (HP System/e Rac k )

5. Depending on the device model, the SAN Switch Rack Mount Kit requires different

screw types for securing the inner rails. Use Table 5 to determine the number and

screw type for y our specific switch .

CAUTION:

Do not use any screws other than those provi ded. Using longer screws

than those provided can cause d amage to internal components.

Table 5 Number of screws required to assemble the inner rails

SAN Switch

#8-32 x 5/16-inch screws #8-32 x 3/16-inch screws

2/32 N/A

12 (Six per rail)

4/8, 4/16

Ten (Five per rail)

N/A

4/32

Ten (Five per rail)

N/A

4/64

Ten (Five per rail)

N/A

4/32B

Six (Three per rail)

N/A

Installing and configuring SAN Switches