- Hewlett-Packard SAN Switch Installation Guide

b. Depending on the rack you are using, complete one of the following tasks:
• For HP 10000 series racks, install two #10-32 x 1/2-inch Phillips
pan-head screws with captive star lock-washers and two #10 adapter
washers in the upper and lower hole locations of the right rail. Then
install two #10-32 x 1/2-inch Phillips pan-head screws with captive star
lock-washers and two #10 adapter washers in the upper and lower
hole locations of the left rail. See Figure 13.
Figure 13 Assembli ng the outer rails (HP 10000 series racks)
•ForanHPS
ystem/e Rack, install two #10-32 x 1/2-inch Phillips
pan-head screws with captive star lock-washers and two #10 alignment
washers in upper and lower hole locations of the right rail. Then, insta ll
two #10-32 x 1/2-inch P hillips pan-head screws with captive star
lock-washers and two #10 alignment washers in the upper and lower
hole locations of the left rail. See Figure 14 on page 46.
SA N Switch installation guide
45