- Hewlett-Packard SAN Switch Installation Guide

CAUTION:
Forproperairflow,theSFPmediasideoftheSANSwitchmustfacetherearoftherack.
To install the switch in a r ack:
1.
Verify that the required parts and hardware are available. See Table 3 on page 36 .
2. Choose a mounting location for the switch in the rack.
3. Attach the rear mounting brackets to the rear rack uprights:
• For HP 10000 series racks, assemble each of the t wo brackets wi th two
#10-32 x 1/2-inch P hillips pan-head screws with captive star lock-washers
and two #10 adapter washers, as shown in Figure 10 on page 43.
• For an HP System/e Rack, install the two rear mounting brackets with
two #10-32 x 1/2-inch Phillips pan-head screws and two #10 alignment
washers, as shown in Figure 11 on page 43.
Figure 10 Installing the rear mounting brackets (HP 10000 series
racks)
Figure 11 Installing the rear mounting bra ckets (HP System/e Ra ck)
NOTE:
Your SAN Switch Rack Mount Kit contains b oth left rails and right rails.
SA N Switch installation guide
43