- Hewlett-Packard SAN Switch Installation Guide

A Regulatory com pliance and
safety
Regulator y compliance
Federal Communications Commission notice for Class A equipment
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Par t 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment
in a residential area is likely to cause harmfu l interferenc e, in which case the
user will be required to correct the interference at his own expense. The end user of this
product should be aware that any changes or modifications m ade to this equipment
without the approval of Hewlett-Packard could result in the product not meeting the Class
A limits,
in which case the FCC could void the user’s authority to operate the equipment.
Declaration of conformity for products marked with the FCC logo, United States
only
This devic e complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
For questions regarding your product, visit h
ttp://www.hp.com.
For questions regarding this FCC declaration, contact us by mail or telephone:
• H ewlett-Packard Company
P.O. Box 692 000, Mailstop 510101
Houston, TX 77269–2000
• 1–281–514–3333
To identify this prod uct, refer to the part, Regulatory Model Number, or product number
found on the product.
SA N Switch installation guide
113