User's Manual
Table Of Contents
- Contents
- Chapter 1. General Checkout
- Chapter 2. General Information
- Chapter 3. Diagnostics
- Setup Utility program
- Product Recovery Program menu
- Diagnostics
- Diagnostics download
- Navigating through the diagnostic programs
- Running diagnostic tests
- Test selection
- Module test menu/hardware configuration report
- Memory Diagnostic tests
- Alert-On LAN™ test
- Asset ID™ test
- Test results
- Hard file Smart test
- Fixed Disk Optimized Test
- Quick and Full erase - hard drive
- Iomega Zip drive test
- Asset EEPROM backup
- Viewing the test log
- When to use the Low-Level Format program
- Preparing the hard disk drive for use
- Chapter 4. Installing Options
- Chapter 5. FRU Replacements
- Chapter 6. Symptom-to-FRU Index
- Chapter 7. Parts
- Chapter 8. Additional Service Information
- Chapter 9. About this manual
- Chapter 10. Related Service Information
Beep symptoms
Beep symptoms are short tones or a series of short tones separated by pauses
(intervals without sound). See the following examples.
Beeps Description
1-2-X
v One beep
v A pause (or break)
v Two beeps
v A pause (or break)
v Any number of breaks
4 Four continuous beeps
Use the following table to diagnose beep symptoms.
Beep Symptom FRU/Action
1-1-3
CMOS read-write error
1. Run Setup
2. System Board
1-1-4
ROM BIOS check error
1. System Board
1-2-X
DMA error
1. System Board
1-3-X
1. Memory Module
2. System Board
1-4-4
1. Keyboard
2. System Board
1-4-X
Error detected in first 64 KB of RAM
1. Memory Module
2. System Board
2-1-1, 2-1-2
1. Run Setup
2. System Board
2-1-X
First 64 KB of RAM failed
1. Memory Module
2. System Board
2-2-2
1. Video Adapter (if installed)
2. System Board
2-2-X
First 64 KB of RAM failed
1. Memory Module
2. System Board
2-3-X
1. Memory Module
2. System Board
2-4-X
1. Run Setup
2. Memory Module
3. System Board
3-1-X
DMA register failed
1. System Board
3-2-4
Keyboard controller failed
1. System Board
2. Keyboard
Chapter 6. Symptom-to-FRU Index 57