User's Manual
Table Of Contents
- Contents
- Chapter 1. General Checkout
- Chapter 2. General Information
- Chapter 3. Diagnostics
- Setup Utility program
- Product Recovery Program menu
- Diagnostics
- Diagnostics download
- Navigating through the diagnostic programs
- Running diagnostic tests
- Test selection
- Module test menu/hardware configuration report
- Memory Diagnostic tests
- Alert-On LAN™ test
- Asset ID™ test
- Test results
- Hard file Smart test
- Fixed Disk Optimized Test
- Quick and Full erase - hard drive
- Iomega Zip drive test
- Asset EEPROM backup
- Viewing the test log
- When to use the Low-Level Format program
- Preparing the hard disk drive for use
- Chapter 4. Installing Options
- Chapter 5. FRU Replacements
- Chapter 6. Symptom-to-FRU Index
- Chapter 7. Parts
- Chapter 8. Additional Service Information
- Chapter 9. About this manual
- Chapter 10. Related Service Information
1 Bay 1 - Max Height: 41.3 mm (1.6 in.)
CD-ROM drive (standard in some models)
5.25-inch hard disk drive
2 Bay 2 - Max Height: 41.3 mm (1.6 in.)
5.25-inch hard disk drive
3.5-inch hard disk drive (requires a mounting bracket)
CD-ROM drive
DVD-ROM drive
3 Bay 3 - Max Height: 25.4 mm (1.0 in.)
3.5-inch diskette drive
4 Bay 4 - Max Height: 25.4 mm (1.0 in.)
Hard disk drive
3.5-inch removable drive
5 Bay 5 - Max Height: 25.4 mm (1.0 in.)
Hard disk drive
6 Bay 6 - Max Height: 25.4 mm (1.0 in.)
Hard disk drive
7 Bay 7 - Max Height: 25.4 mm (1.0 in.)
Hard disk drive
Installing internal drives in bays 1, 2, 3 and 4
1. Remove the cover (see “Removing the cover” on page 15).
2. If the drive you are installing is a removable-media drive, remove the bay
panel from the front bezel.
3. Insert a flat–bladed screwdriver into one of the slots on the static shield in the
drive bay into which you are installing the drive and gently pry the static
shield loose from the drive bay.
Chapter 4. Installing Options 17