Datasheet

8068ch11-SAN Config.fm Draft Document for Review January 29, 2013 12:52 pm
450 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
It is necessary to complete the above steps in the correct order for the configuration to be
successful. In Example 11-1 the ISCLI commands display shows the Omni ports EXT11-12
are changed from their ethernet default to Fibre Channel after the Converged Enhanced
Ethernet (CEE) and FCoE Initialization Protocol (FIP) snooping is enabled. The FCoE VLAN
is then created and then the ports are assigned to the VLAN
Example 11-1 Configuring ports, creating VLAN and port assigning
Router(config)#cee enable-----------------------------------------> CEE Enabled
Router(config)#cfcoe fips enable---------------------------------> FIPS Enabled
Router(config)#system port EXT11-EXT12 type fc ---------------> FC Mode Enabled
Router(config)#
Oct 26 14:22:12 fd8c:215d:178e:c0de:3640:b5ff:fe5c:f5ef NOTICE lldp: LLDP TX & RX
are disabled on port EXT11
Oct 26 14:22:12 fd8c:215d:178e:c0de:3640:b5ff:fe5c:f5ef NOTICE lldp: LLDP TX & RX
are disabled on port EXT12
Router(config)#vlan 1002
VLAN 1002 is created---------------------------------------------->VLAN Created
Router(config-vlan)#member INTA3-INTA4,INTA11-------------> Ports added to VLAN
Port INTA3 is an UNTAGGED port and its PVID is changed from 1 to 1002
Port INTA4 is an UNTAGGED port and its PVID is changed from 1 to 1002
Port INTA11 is an UNTAGGED port and its PVID is changed from 1 to 1002
Router(config-vlan)#member EXT11-EXT12--------------------> Ports added to VLAN
Router(config-vlan)
Example 11-2 shows an abbreviated version of the ISCLI command output for show
fc-internals command, this shows that the Omni ports EXT11 and EXT12 have been FC
enabled and are assigned to VLAN 1002.
Example 11-2 Checking Omni ports are correctly configured for FC
Alias Port FC VLAN VLAN-Mode EACL IPG
----- ---- -- ---- --------- ---- ---
EXT11 53 Y 1002 FCF Y Y
EXT12 54 Y 1002 FCF Y Y
EXT13 55 N 1 N/A N N
EXT14 56 N 1 N/A N N
EXT15 57 N 1 N/A N N
EXT16 58 N 1 N/A N N
Example 11-3 shows all ports have been successfully added to VLAN 1002 with VLAN
enabled.
Example 11-3 Display VLAN and ports
Router(config-vlan)#show vlan
VLAN Name Status MGT Ports
---- -------------------------------- ------ --- -------------------------
1 Default VLAN ena dis INTA1 INTA2 INTA5-INTA10
INTA12-INTA14 EXT1 EXT2
EXT11-EXT16
1002 VLAN 1002 ena dis INTA3 INTA4 INTA11 EXT11
EXT12
4095 Mgmt VLAN ena ena EXTM MGT1