Datasheet

Chapter 7. Migration wizard 279
Draft Document for Review January 29, 2013 12:52 pm 8068ch07-Migration.fm
5. Configure the host that needs to access the data after the migration, or create new hosts
as needed in Step 5, and click Next (Figure 7-14).
Figure 7-14 Storage Migration Wizard step 5 - Configure Hosts
Before you configure any hosts, make sure that the appropriate drivers have been
installed on the host and that the host zones have been zoned correctly.
If the host that needs to access the data on the volume after the migration is complete is in
the list, select the host and click Next.
If the host has not been created on the IBM Flex System V7000 Storage Node storage
system, click New Host to create it and follow the instructions for creating the new host. In
our example we assume that the IBM Flex System V7000 Storage Node already has been
configured with the correct host and corresponding World Wide Names or iSCSI
addresses. After the host has been created, you can find it in the host list.
6. Click Map to Host for making the disks available to the host during migration as shown in
Figure 7-15 on page 280.