Datasheet

8068ch06-Volumes.fm Draft Document for Review January 29, 2013 12:52 pm
262 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
If you clicked Create the next logical step is to map the newly created volume to a host. If you
clicked Create and Map to Host the volume create wizard takes you to the host mapping
wizard as shown below.
To map the volumes, complete the following steps:
1. From the volumes menu select a volume and click either Actions and Map to Host or
right-click and select Map to host as shown in Figure 6-31.
Figure 6-31 The volumes menu - map to host
2. Select a host to which the new volume should be attached (Figure 6-32).
Figure 6-32 Map to host - choose host
3. The Modify Mappings window opens, and your host and the newly created volume are
already selected. Click OK and the volume is mapped to the host (Figure 6-33 on
page 263).