Datasheet

Chapter 4. IBM Flex System V7000 Storage Node Initial Configuration 171

Draft Document for Review January 29, 2013 12:52 pm 8068ch04-Initial Config.fm

Figure 4-28 Change Service IP via management GUI procedure

Change Service IP via CMM

If CMM in the chassis is operating and reachable, you can use the CMM to change the

Service IP address of a node canister, as shown in Figure 4-29 on page 172.

1. Open the CMM and navigate to the Chassis Management  Component IP

Configuration page

2. In the list of Storage Nodes, click on the name of the node canister.

3. In the IP address Configuration panel, click the IPv4 tab.

4. Select Node_Service_If as the Network Interface and select the Configuration Method

you wish to use. If the selected Configuration Method is to Use Static IP address (as

shown in Figure 4-29 on page 172), type the Static IP address, Subnet Mask, and

Gateway address for the New Static IP Configuration.

5. Click Apply and then Close

Note: If, for example, the canister has failed to obtain a DHCP address and a default

Service IP address in the range between 192.168.70.131 and 192.168.70.144 is displayed,

the canister has failed to obtain a DHCP address.