Datasheet

Chapter 11. SAN Connections and Configuration 453
Draft Document for Review January 29, 2013 12:52 pm 8068ch11-SAN Config.fm
򐂰 Create Zone
򐂰 Create Zoneset
򐂰 Activate Zoneset
This process is very much the same as is used on FC zoning. Example 11-6 shows from the
ISCLI creating a zones and populating it with PWWNs from Compute Node 11 and each
canister of the IBM Flex System V7000 Storage Node.
Example 11-6 Creating Zone and Zoneset
Router(config)#zone name FSV7K_N11---------------------------------> Create Zone
Router(config-zone)#member pwwn 50:05:07:68:05:04:02:50
Router(config-zone)#member pwwn 50:05:07:68:05:04:02:51
Router(config-zone)#member pwwn 10:00:5c:f3:fc:6e:30:01--------> Add PWWN members
Router(config-zone)#show zone
zone name FSV7K_N11
pwwn 50:05:07:68:05:04:02:50
pwwn 50:05:07:68:05:04:02:51
pwwn 10:00:5c:f3:fc:6e:30:01
Router(config-zone)#zoneset name CN4093_1------------------------> Create Zoneset
Router(config-zoneset)#member FSV7K_N11---------------------> Add Zone to Zoneset
Router(config-zoneset)#show zoneset-------------------------------> Check Zoneset
zoneset name CN4093_1
zone name FSV7K_N11
pwwn 50:05:07:68:05:04:02:50
pwwn 50:05:07:68:05:04:02:51
pwwn 10:00:5c:f3:fc:6e:30:01
zoneset name FCOE_Zoneset1
Example 11-7 shows from the ISCLI activating the zoneset and then checking to ensure the
configuration and active zoneset are correct.
Example 11-7 Activating and checking zoneset
Router(config-zoneset)#zoneset activate name CN4093_1----------> Activate Zoneset
Router(config)#show zoneset active-----------------------------> Check Activation
Active Zoneset CN4093_1 has 1 zones
zoneset name CN4093_1
zone name FSV7K_N11
pwwn 50:05:07:68:05:04:02:50
pwwn 50:05:07:68:05:04:02:51
pwwn 10:00:5c:f3:fc:6e:30:01
Default-Zone Deny
Router(config)#
Once this is successfully completed the PWWN should be visible from the IBM Flex System
V7000 Storage Node where a host can be created and storage allocated.
Figure 11-15 on page 454 shows the PWWN from the FCoE attached Compute Node 11 is
seen from the administrative GUI of the IBM Flex System V7000 Storage Node. It can be
used to define a host and host port so that volumes can be assigned.
It is important to remember that this entire process has to be repeated on the IBM Flex
System CN4054 10Gb Virtual Fabric Adapter residing in I/O Module port 2 in the IBM Flex