Installation manual

A Guide To IBM System x Power Distribution Units (PDU) - International
P a g e | 41 © IBM Corporation 2012
Enterprise Deep PDU Mount Options
Hardware is included for EIA mounting (U space), side of rack, and side pocket mounting; only sided of rack and side pocket
mounting installation is approved for reconfigured shipment in an IBM rack.
Horizontal installation of a PDU is not supported during relocation or shipping of a rack cabinet. You must remove any
horizontally mounted PDUs from the EIA mounting space before you relocate the rack cabinet.
Supported with:
39M2816 – DPI Enterprise PDU+ (C13)
71762MX – Ultra Density Enterprise PDU+
71762NX – Ultra Density Enterprise PDU
44T0966 – 1U Higher Voltage DC PDU
Mounting In the Side of a Rack
The vertical mounting plates, which ships with
the IBM Switched PDUs, will need to be used
for this installation option.
Mounting In IBM Enterprise Rack (9308 & 1410) & IBM Enterprise V2 Rack (9363) Rear Zero Pocket
The horizontal mounting bracket, which ships
with the IBM Switched PDUs, will need to be
used for this installation option.