Installation manual

A Guide To IBM System x Power Distribution Units (PDU) - International

P a g e | 28 © IBM Corporation 2012

40K9611 - IBM DPI 32A Cord (IEC 309 3P+N+G)

IEC-309 3P+N+G (4.3m) 32A, 3P5W plug (Type 532P6W)

32A (32A / Phase) 380-415VAC Three Phase Wye

96A Total Circuit Capacity

Only a receptacle or a connector is needed to mate with the plug on the PDU input line cord. See section “IEC 309 Pin &

Sleeve Plug Decode” on page 60 in this document for further details on IEC309.

Matching receptacle listing 532R6W IP-67 HUBBELL, Hubbell receptacle P/N HBL532R6W

Matching connector listing 532C6W IP-67 HUBBELL, Hubbell connector P/N HBL532C6W

Used with:

46M4002 – 1U 9 C19 / 3 C13 Switched and Monitored

46M4004 – 1U 12 C13 Switched and Monitored

71762MX – DPI Ultra Density Enterprise PDU+

71762NX – DPI Ultra Density Enterprise PDU

39M2816 – DPI Enterprise PDU+ (C13)

39Y8941 – DPI Enterprise PDU (C13)

39Y8948 – DPI Enterprise PDU (C19)

Re-termination in Australia/New Zealand

The IEC-309 3P+N+G may need to be replaced in AUS/NZ with Clipsal P/N 56PA532 (5 Wire, Three Phase Wye) plug.

Male PinFemale Sleeve

EQUIP.

GR.

L2 L3

L2L3

SYS.

GR.

380- 415V

380-415V

380- 415V

220-240V

220- 240V

Male PinFemale Sleeve

Earth

GR.

415V

SYS.

GR.

240V