Installation manual

A Guide To IBM System x Power Distribution Units (PDU) - International

P a g e | 26 © IBM Corporation 2012

Front End (39Y8934) 220-240VAC / 32A Cord (IEC 309 P+N+G)

IEC 309 P+N+G (2.5m) - 32A 220-240VAC Single Phase

Only a receptacle or a connector is needed to mate with the plug on the PDU input line cord. See section “IEC 309 Pin &

Sleeve Plug Decode” on page 60 in this document for further details on IEC309.

Matching receptacle listing 332R6W IP-67 HUBBELL, Hubbell receptacle P/N HBL332R6W

Matching connector listing 332C6W IP-67 HUBBELL, Hubbell connector P/N HBL332C6W

Note that this is not the same cord as the 40K9612 cord. PDU line cord connector pin out is different.

Used with:

39Y8934 – Front End PDU

Front End (39Y8935) 220-240VAC / 63A Cord (IEC 309 P+N+G)

IEC 309 P+N+G (2.5m) - 63A 220- 240VAC Single Phase

Only a receptacle or a connector is needed to mate with the plug on the PDU input line cord. See section “IEC 309 Pin &

Sleeve Plug Decode” on page 60 in this document for further details on IEC309.

Matching receptacle listing 363R6W IP-67 HUBBELL, Hubbell receptacle P/N HBL363R6W

Matching connector listing 363C6W IP-67 HUBBELL, Hubbell connector P/N HBL363C6W

Note that this is not the same cord as the 40K9613 cord. PDU line cord connector pin out is different.

Used with:

39Y8935 - Front End PDU

Male PinFemale Sleeve

N L

EQUIP.

GR.

220- 240V