Datasheet

shipping key. autoloader has been removed.
Command Failed Drive is Full A command was issued from the
operator panel to load a cartridge into
the tape drive when the drive already
contained a cartridge.
Wait until the current cartridge is
uploaded by the application, or use the
operator panel to unload it from the tape
drive.
Command Rejected Carousel Full A command was issued from the
operator panel to load a cartridge into
the autoloader when all of the cartridge
cells were already full.
Export a cartridge from the autoloader
to make room for a new cartridge.
Command Reject Empty Carousel A command was issued from the
operator panel to either load a cartridge
into the tape drive or remove a cartridge
from the autoloader when there were no
cartridges in the cartridge carousel.
Wait until the cartridge is ejected from
the tape drive, or use the operator panel
to import cartridges into the autoloader.
Configuration Locked by Host The application is currently controlling
the autoloader(a SCSI command is
active) or the Remote Management
utility is controlling the autoloader.
Wait for the command from the
application to complete
Device Not Ready The autoloader is not ready to perform
the requested operation because it is
performing diagnostics or it power-on
self-test has not completed.
Wait until the autoloader has finished,
then retry the operation.
Drive CMD Error The tape drive received an invalid
command
z If possible, use thee operator
panel to unload any cartridge that
is in the tape drive.
z Power the autoloader off and
back on to reset the tape drive.
z If the error persists, contact your
service provider.
Drive Load Fail The cartridge could not be loaded into
the tape drive because of a mechanical
problem or because of a broken tape.
z Export the tape from the
autoloader and verify the tape is
in good condition, then retry the
operation.
z If the error persists, contact your
service provider.
Drive Timeout The tape drive took too long to load or
unload a tape, or the tape drive is not
responding.
z If possible, use the operator panel
to unload any cartridge that is in
the tape drive.
z Power the autoloader off and
back on to reset the tape drive.
z If the error persist, contact your
service provider.
Drv Unload Fail The cartridge could not be unloaded
from the tape drive because of a
mechanical problem.
z Power the autoloader off and
back on to reset the tape drive.
z Retry the unload operation once.
z If the error persist, contact your
service provider.
H/W Inoperable An operation could not be completed
because of a mechanical problem.
z Reset the autoloader and retry the
operation.
Page 26 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html