Datasheet

97 With the door open
98 At completion
99 Unexpectedly
100 Cartridge is still in the picker arm
101 Already on the platform at the start of the load
6D The door is open after a magazine has been inserted,
or after an attempt to lock it
104 After a load
105 When the door is locked
106 Door did not close
107 Lock broken
6E A cartridge in the picker fingers has become loose 112 During X-motion
113 During upward Y-motion
114 During Y-motion up to the slot
115 During downward Y-motion
116 During Y-motion down to the slot
117 During unload
6F The tape has not been loaded in the drive successfully,
even though the changer mechanism has apparently
delivered it successfully.
120 Premature ejection. The drive accepted the tape, but
then had a problem, such as a snapped tape or
misload.
121 The drive failed to induct the cartridge, probably
because of a changer mechanism problem
70 The X-motor is jammed 128 Approaching the door without a cartridge
129 Approaching the door with a cartridge
130 Leaving the cartridge
131 Looking for no slot
132 Pushing the cartridge
71 The X-motor has not responded within the time-out
period
136 Approaching the door without a cartridge
137 Approaching the door with a cartridge
138 Looking for no slot
139 Pushing the cartridge
140 Retrying initialization
72 The diagnostic to test sensor status detected that the
sensor is inactive. This is not necessarily a fault.
144
73 The Y-motor has not responded within the time-out
period on downward motion
152 Going down to the home position
153 Going down
154 Going down to the slot
155 Going down with a cartridge
156 Going down to the slot with a cartridge
157 Going down below the home position
158 Going down to the door
159 Opening the door
74 A cartridge has been accidentally pushed into the
drive. The cartridge was then either physically loaded,
or ejected and returned to the magazine.
160 Cartridge pushed into drive
161 Unload pushed into drive
Page 23 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html