Datasheet

z Y-motion:
The movement up and down of the platform in an autoloader when carrying cartridges between the magazine and the
drive.
z Z-motion:
The motion of the magazine transport in an autoloader when it takes a magazine that the user has inserted and conveys
it to the carousel. The same motion in reverse is used to eject the magazine.
Table 7. LCD 2 Digit Error Display
Code Description LCD
61 Z-motor jammed while loading or ejecting the
magazine
8 While pulling in
9 While reversing load
10 While pushing out
11 While starting to unload
12 While unloading
13 Diagnostic
62 Z-motor has not responded within the time-out period. 16 Completing load
17 Loading a magazine
18 Pulling the magazine in
19 Starting the unload
20 Unloading the magazine
21 Diagnostic
63 A magazine load was attempted, but no magazine was
in the autoloader. This should never occur and is
likely a firmware error.
24 Magazine not loaded
25 Magazine reinserted
64 The R-motor is jammed, failing to rotate the carousel. 32 Leaving the home position
33 Moving away from the home position
34 Turning to the away position
35 Leaving the away position
36 Moving away from the away position
37 Turning to the home position
38 Recovering position
65 The R-motor has not responded within the time-out
period
40 Leaving the home position
42 Unexpected home R-switch
43 Turning to the away position
44 Unexpected away R-switch
45 Turning to the home position
46 Recovering position
66 The Y-motor has not responded within the time-out
period on upward motion
48 At power-on
49 Going up to the home position
50 Going up
51 Going up to the slot
52 Going up with the cartridge
53 Going up to the slot with the cartridge
Page 21 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html