Datasheet

Error Action: Check the SCSI interface connection and try again.
Search << 1012 S The drive is searching for a record, filemark, setmark, or Beginning of Data(BOD)
toward the beginning of the tape.
Search >> 1011 S The drive is searching for a record, filemark, setmark, or End of Data(EOD) toward the
end of the tape.
Select
Lock
1022 I Tape selection is locked. SCSI Prevent Medium Removal is in operation.
Select
Tape
2008 I This is displayed when you press the Select button, and for a short time after the button
is released.
Self Test 0000 S The autoloader is preforming its power-on self-test.
Semi
Loaded
1007 S A cartridge is in the drive but not loaded.
Stray
Tape:
Insert
Empty
Mag
2003 I There is a cartridge in the autoloader but there is no magazine present to put it into.
Action: Insert an empty magazine to retrieve the cartridge.
Tape
Fault
8006 E F The cartridge in the drive is faulty, possibly because the tape has snapped, or the
cartridge has an invalid pattern of identification holes.
Action: Use a new cartridge and insure it is a DDS2, DDS3, or DDS4 cartridge.
Tape Full 1024 E F A READ, SPACE, WRITE, or WRITE Filemark command encountered End Of Tape
(EOT) unexpectedly. When reading this may mean the required data is on the next
cartridge.
Tape has
DC data
8019 E F A READ command has encountered compressed data on the tape, and the drive is not
currently configured to decompress data. The host may have disabled data compression.
Action: Check that the host has not disabled data compression.
Tape
Position
Lost
8013 E F A WRITE, READ, SPACE, or REWIND command has failed to complete. The Tape is
positioned on the far side of the bad data.
Tape
Stuck
8008 E F The cartridge is stuck in the drive.
Action: Try forcing an eject. To force an eject hold the eject button for 5 seconds. For a
detail of the forced eject refer to "Emergency Ejection" in the 7332-220 Setup and
operator guide.
Unable to
boot
Cleaning
tape
4002 I The system cannot boot from a cleaning tape.
Unloading 1004 S Either the drive is unloading a cartridge, or a cartridge is being ejected from the drive
and replaced in the magazine.
Upgrade
Err
8022 E F The autoloader has failed to download an upgrade of the firmware via SCSI.
Action: Check the SCSI connection and try again.
Worn
Media
8015 E O A high error rate has been detected while writing, suggesting that the tape is nearing the
end of its useful life.
Action: Copy any data you wish to keep from the cartridge onto a new cartridge and
discard the old cartridge.
Write x.y 1010 S The drive is writing data to the tape. x.y:1 is the cumulative compression ration since
power-on, or since the compression ration was last cleared. For example, Write 2.1
means a compression ratio of 2.1:1. The compression ration is on displayed after about 1
megabyte of data has been written since power-on.
Page 19 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html