Datasheet
7332-220 4mm Autoloader:
The informational area of the autoloader contains 2 information areas, LEDs and a multifunctional LCD.
LED's description are from top to bottom:
Note: Where
opening properly.
70 Magazine Position Unknown Position of magazine changed due to
shock or vibration.
Recycle power to the autoloader.
Replace drive due to faulty sensor.
B2 Magazine Scanning Failure Stuck tape cartridge or tape cartridge
improperly inserted.
Clean the magazine rollers.
B3 Magazine Position Failure Stuck tape cartridge or tape cartridge
improperly inserted.
Clean the magazine rollers.
F0 Power-on Failure Cartridge stuck or magazine locked
up when powering on the autoloader.
Recycle power to the autoloader.
Green -
Ready
(Ma
g
azine
Loaded)
Green -
Tape
and
Tape
Activit
y
Amber -
Disturbance
Meaning
* * On One of the following conditions:
z The tape path needs cleaning(refer to the tape drive cleaning instructions).
z A cleaning cartridge has been inserted and the cleaning cartridge has exceeded
the maximum number of cleanings for the cleaning cartridge.
Flashing Off Off The Power-On Self Test(POST) is running
OR
A magazine is being installed, checked or ejected.
Off Off Off One of the following conditions:
z The power is Off
z The POST has completed successfully, but no tape cartridge has been inserted.
On Off * A magazine has been installed.
On Flashing Off One of the following conditions:
z A tape cartridge has been inserted and the tape drive is busy running a device
command.
z The tape drive is performing a tape load/unload operation,
z The tape drive is in a cleaning operation.
On On * A tape cartridge has been inserted and the drive is ready to receive commands from the
system.
* * Flashing One of the following conditions:
z The tape drive has detected an internal fault that requires corrective action. Reset
the drive by pressing the blue Eject button. If this does not clear the condition,
power the drive off then back on.
If the condition cannot be cleared using this method, refer to your service guide
or system diagnostics for further assistance.
The AIX diagnostic command:
diag -c -d rmtx <-where x is the tape drive#
will issue a reset to the tape drive if AIX is able to communicate with the drive.
z A manual microcode download was attempted and failed. Power the drive off
and then back on to clear this condition.
Page 15 of 93Tape Help Package
5/20/2008file://C:\tem
p
\TAPEWHDR.html