Network Router User Manual

Defining ports or assets to exclude from a scan
Use the Scan Exclusion policy on the SiteProtector Console to define the specific
ports, specific assets, or both, that you want to exclude from a scan of a group of
assets.
Procedure
1. From the SiteProtector Console, create a tab to display asset policies.
2. In the navigation pane, select a group, and then open the Scan Exclusion policy
for that group.
3. Choose an option:
If you want to... Then...
Exclude ports Use a combination of typing the ports to
exclude and choosing the ports:
v Type the ports to exclude, separated by
commas, in the Excluded Ports box.
v Click Well Known Ports, and then select
the ports to exclude.
Exclude assets Type the IP addresses (in dotted-decimal or
CIDR notation) of the hosts to exclude in the
Excluded Hosts box:
v Type an IP address, and then press ENTER.
v Type a range of IP addresses, and then
press ENTER.
Example: 172.1.1.100-172.1.1.200
v Type a series of individual IP addresses, a
range of addresses separated by commas,
or both, and then press ENTER.
Note: A red box is displayed around the
Excluded Hosts box until the data is
validated.
Chapter 5. Background scanning in SiteProtector 87