- IBM switch Users and Maintenance Guide

Attention: When connecting the DS4100 to DS4000 EXP100 storage

expansion units, DO NOT use the tens digit (x10) setting. Use only the

ones digit (x1) setting to set unique server IDs or enclosure IDs. For more

information, see “Server ID (enclosure ID) settings” on page 33.

Gbps/2 Gbps switch

The default switch setting is 2 Gbps. This is the only speed setting that is

allowed for the DS4100.

Attention: Do not remove the metal plate that covers the storage server

speed setting. Do not adjust the storage server speed setting.

Storage server operating environment

This section provides general operating information about the DS4100. All

components plug directly into the backplane.

Chapter 1. Introduction 13