Installation Guide

386-257-1187

iBEAMUSA.com

Camera Wiring

There are two options for powering up the camera.This

camera can be powered to be available while the vehicle

is running or to only be used as a back-up camera.

Power camera with reverse

1. Remove the tail light from the vehicle to allow

access to the light bulbs wiring. (If help is needed,

review the vehicles owners manual section on

replacing the tail light bulbs.) (Figure A)

2. Find the wiring that connects to the reverse bulb.

There is normally 2 wires. (Figure B) Strip the

insulation to expose the copper wire.

3. Using a Digital Multi-meter on the DC Voltage

setting, to verify the reverse wire. (Figure C)

4. Connect the RED wire to the reverse wire.

Connect the BLACK wire to a chassis ground.

NOTE: If lighting circuit has pulse width modulation,

please use part # TE-CAMFLTR.

Power camera with accessory

1. Find a reliable 12 volt accessory source in the

vehicle. This can be found at the radio if it is being

replaced with an aftermarket radio.

2. Using a Digital Multi-meter on the DC Voltage

setting, to verify the accessory wire. (Figure C)

3. Connect the RED wire to the accessory wire.

Connect the BLACK wire to a chassis ground.

Figure C

Figure B

Figure A

12 V

- 12V

Select this symbol on the meter

CAMERA WIRING