Installation Guide

ManualsBrandsiBEAM ManualsBack-Up & Dash CamerasLicense Plate Backup Camera

iBEAMUSA.comiBEAM Vehicle Safety Sytems

REV. 07/13/2020 INSTTE-2MPIR

Attention!

When testing the aftermarket

equipment, ensure that all factory equip-

ment is connected before cycling the key to

ignition.

TE-2MPIR

INSTALLATION INSTRUCTIONS

#IBEAMSAFETY

Wiring ..................................................................2-3

Camera mounting options.....................................3

Specifications .........................................................4

TABLE OF CONTENTS

TOOLS REQUIRED

• Wire stripper

• Tape

• Digital Multi-meter

• Cutter

Universal IR Accessory Camera

With Multi-mounts

Visit iBEAMUSA.com for more detailed informatuon about the product and up-to-date vehicle specific

applications.

Product Features

• Multiple mounts included - license plate and surface mount

• Improved power circuit

• Can be viewed while driving with compartible monitor

• Ability to trigger IRs separetely from the camera’s power

• Water resistant - IP67

• 3 year warranty

Multi-Mounting Options

A) License plate mount B) Surface mount

A B

Part Components

• Camera

• License plate and surface mount

• Extension harness (27 FT)

• Screws

Summary of content (4 pages)

PAGE 1
TE-2MPIR INSTALLATION INSTRUCTIONS #IBEAMSAFETY Universal IR Accessory Camera With Multi-mounts Visit iBEAMUSA.com for more detailed informatuon about the product and up-to-date vehicle specific applications.
PAGE 2
CAMERA WIRING 27 FT Connect the RED wire labeled 12V acc. to the vehicles ignition 5 FT Connect the BLACK wire labeled Ground to chassis ground 12V ACC GROUND MONITOR IR/PARKING LINE TRIGGER (12V) IR/PARKING LINE TRIGGER (12V) Connect one GREEN wire labeled TRIGGER to the vehicles reverse wire. • Applying 12 volts to this wire activates the IRs and Parking lines when in reverse. • This wire can be used if reverse is needed at the opposite end of the vehicle, EX.
PAGE 3
CAMERA WIRING (CONT.) & MOUTNING OPTIONS 1. Run the extension cable to the front of the vehicle. (Figure A) 2. Connect the YELLOW RCA to the backup camera or video input of the monitor Figure A This camera comes with two mounting options. • Behind license plate mount (Figure B) • Surface mount (Figure C) Using the two small phillips head screws on the rear of the camera, the mounts can be switched. Photo shows camera in both mounting options, 1 camera in box. Figure B Figure C REV.
PAGE 4
TE-2MPIR INSTALLATION INSTRUCTIONS #IBEAMSAFETY Sensor Effective Pixel Sync Frequency Resolution S/N Ratio Current Consumption Power Supply Operating Temp. Storage Temp. Viewing Angle (Dia.) Water Resistance Min. Illumination iBEAM Vehicle Safety Sytems ® CMOS II 648 X 488 NTSC 60 HZ 420 TV Lines More than 48dB No more than 150mA DC 12V +- 10% -22 ~ 176 F -40 ~ 176 F 170 IP67 0.5/F1.2 LUX - 0 LUX IRs on iBEAMUSA.com Having difficulties? We’re here to help.