User's Manual

iBaby MonitorUser Manual
17
Answer: Red indicates that iBaby is not connected to your WI-FI. The solution is
as follows:
1) Please confirm the WI-FI password, and then restart the device and re-install
it.
2) Please install iBaby in a place with good WI-FI signal. The WI-FI name and
password are preferably 8-32 characters in upper and lower case letters, numbers,
- or underscores. They cannot contain special characters (such as Chinese
characters, Japanese). , Korean, etc.).
3) The SSID broadcast on the router should be turned on.
5) WPA2-PSK is selected for the WI-FI authentication type on the router, and AES
is selected for the encryption algorithm.
Note:
After entering the password, immediately enter the installation, the installation
progress bar, at around 5%, iBaby will make two beeps, after the installation is
complete, the green light is always on.
If you don't hear the "beep" sound, you need to take the device to the side of the
router to install, and power off and restart the router, it is best to change the
time period before installing.
Question 3 Prompt during installation, if you can't see any progress, please click
Cancel (LED status light behind iBaby, green flashing)