Instructions

05 - 06
User Manual
05
INSTALLATION CUBO RAISED ANCHOR
Use a Phillips head screwdriver to tighten the
screws holding the side anchors.
This time, the entry to the connectors is direct
with I/O connectors.
Connect power to the V/D: insert the cable into
direct opening B and connect to the RJ-45,
connect the other cable to the V/D plate A.
A
B
Detailed view of the rear of the direct access
06
07
Place the product properly on the edge of the
table for installing. Pic 7.
Once the support is seated, turning the lower
screws counter-clockwise for fixing on desk.
The support is fully installed.
INSTALLATION CUBO SUPPORT 2
Important: Maximum rank 40mm
For any questions about the product
Get in touch with:
[e-mail]
08