Stealth Rekon Hedaset (IA-NT4-BASIC-BT) Operating Instructions v3.0 Stealth Parts Reference 1. Vol + / Next Track 2. Vol - / Previous Track 3. Primary Button: Power/Pairing/Pause/Play (w/ Micro-USB charging port underneath it) 4. Primary Button Cap 5. Magnetic clasp base 6. Magnetic clasp top 7. Acoustic coil module 8. 3.5mm (recessed/thin jack) module 9. Helmet speaker 3.
Stealth Rekon Hedaset (IA-NT4-BASIC-BT) Operating Instructions v3.0 Thank you for purchasing the preproduction version of our Stealth Bluetooth Throat Mic. In this document you will find instructions on operating the Stealth with Bluetooth enabled devices. Should there be any questions, feel free to contact us at info@iasusconcepts.com.
Controls The Stealth was designed with 3 basic buttons for control. The Primary Button is located on the left side of the neck and the button cap is made of silicone with an indicator LED located behind it. A pair of buttons for volume up/down/skipping tracks are located on the wing blade, with beveled + and – on them. All control buttons are designed to be operated with ease even when gloves are worn. Refer to the following table for functions of the buttons.
Pairing The IASUS Stealth uses standard Bluetooth 5.0 protocols. When paired with newer devices, there is no need to enter a passcode. For older Bluetooth equipped devices, the code is “0000”. The device name is “Stealth Headset”. Pairing Second Device The Stealth allows for pairing with two Bluetooth enabled devices at the same time, such as another smart phone, GPS, mp3 player, etc.
Interchangeable Audio Module The Stealth can operate with our acoustic coil or helmet speakers which use the 3.5mm recess/thin audio connector. This is done by installing the appropriate audio module. To properly attach these modules, they need to be turned clockwise and tightened very firmly until the IASUS logo is horizontal and right side up. This position ensures proper alignment with the contacts.
Indicator LED Definitions LED State Description Blue LED on once every second All profiles on standby; Stealth not paired with any Bluetooth device Blue LED flashes once every 2 seconds Paired; Phone or Music profile connected Blue LED flashes twice every 2 seconds On music streaming state Blue LED on once every second (during call) On active call state Red LED and Blue LED flash alternately Pairing mode When Red LED replaces any Blue LED indicators above Low battery Red LED on solid Battery
Adjusting the Length of the Acoustic Coil For customizing the length of the acoustic coil, you will need the included Acoustic Coil Customization Adaptor (IA-ACADP) in order to shorten the coil. Follow the instructions below. Step 1: Using a pair of scissors, cut the coil at the area shown in diagram 1. Step 2: Cut the coil to your desired length. We recommend cutting no more than 1cm at a time. Step 3: Insert the metal adaptor and connect the two piece of the coil.
Frequently Asked Questions Q: I paired the Stealth to my PC and when Windows tried to automatically install the drivers for the Stealth, it comes back with multiple “Bluetooth Peripheral Device – No Driver Found” errors. Where can I find the drivers? A: This means Windows was not able to find any Bluetooth drivers for your PC hardware. Please ensure you have your computer manufacturer’s Bluetooth software suite installed and try to pair the Stealth again.
