Operating Instructions

Note

Never connect the LCD screen and illuminator module to any

other equipment other than the Bestguarder camera module.

Never connect any other equipment to the Bestguarder (AV)

socket on the back of the camera module. Failure to do so may

result in damage to the Bestguarder equipment and may

invalidate the guarantee.

The Bestguarder equipment is not water proof, only water

resistant. Always cover the equipment in rainy conditions.

Setting up the Bestguarder Equipment

Step 1

Put in batteries. Fully charge the battery before using the

Bestguarder product.

Step 2

Fix the LCD Screen and illuminator module to the scope. Check

the size of the rifle scope and select the appropriate clamp from

the Bestguarder kit. (1 inch or 30mm)

Remove the fixing bolt from the clamp. Open up the clamp and

slid over the scope. Then replace the fixing bolt and knob. Slide

the LCD Screen illuminator module into the slot of the clamp.

Then tighten the knob until the LCD screen and illuminator

module is secure. Check that the LCD screen is facing the eye

piece. Do not over tighten the clamp as this may cause strain

damage to the clamp.

Step 3

Select a rubber scope sleeve to suit your scope, and place onto

the scope eye bell. Push the camera module into the end of the

sleeve. For focussing the camera module,please refer to page

11.

Step 4