Operating Instructions

17
Frequently Asked Questions
The unit is not switching on.
Make sure the battery is fully charged See page 15. Make sure the
battery plug is firmly connected to the camera module power socket.
See? Make sure the on/off button on the back of the camera module is
in the ON position (pushed in)
Does the Bestguarder unit consume
No. Providing the on/off button on the back of the camera module is in
power even when the power button
the off position (pushed out) the unit will no longer consume power
Is my Bestguarder water proof?
No, Bestguarder products are water resistant. Cover the Bestguarder
in rainy
conditions.
What type of scopes work best
You get the very best from the Bestguarder system with turn collar
zoom
with the Bestguarder system?
and front or side parallax focussing. Also scopes with fewer or no lens
coatings that can filter out the infra-red light.
My Bestguarder does not give
visibility at
The Bestguarder is dependant on the camera receiving as much
reflected
night at the ranges specified?
infra-red light from the illuminator as possible. Some scopes have
special coatings that can filter out the infra-red light thus reducing the
range of visibility. Always check your scope manufacturers
details.(See page 18 lens coatings).
Will the Bestguarder work in freezing
Yes. The Bestguarder units have an operating temperature
approximately
conditions?
between -10 and 45 degrees centigrade.
Can the Bestguarder withstand the
recoil
The Bestguarder product has been successfully tested with 100
rounds
of large calibre rifles?
consecutively fired from a range of centre fire rifles up to and including
a 0.450 calibre rifle without moderators. Springer air rifles are also
suitable. Please use the anti recoil clamp shown on page 8.
The rubber scope sleeve does not fit
Try warming the scope sleeve in very hot water (boiling is acceptable)
my scope eye piece.
This technique will make the sleeve more pliable to fit over most eye
pieces.
I cannot mount the scope sleeve on
Try un-screwing the eye piece to its maximum point. This may create a
my eyepiece because it’s not a
longer distance for the scope sleeve to grip the scope, then follow the
perfect circle
instructions for re-focus the camera module on page 7 & 8.
I cannot get my scope cross heir in
It is likely that the perfect focal point has been missed. Turn the lens
focus.
fully clockwise until it can be turned no further. Carefully follow the
focussing process on page 7 & 8.
The Wi-Fi buddy share is not
Turn off and on the camera module and wait for the device to
working.
synchronise with the camera module. Also try turning the Wi-Fi off and
on again on viewing device.
When I use the zoom feature on my
This is a normal feature of the Bestguarder system the scope when
scope the distance I can see is
increasing the magnification is reducing the angle of vision thus
reduced.
reducing the visible light therefore reducing the visible range.
There is no image on my LCD
Check that the LCD screen dimmer has not been turned down to
screen when I switch on the unit
the off position (fully anticlockwise)
For more Frequently asked questions go to our website at www.Bestguarder.com or visit our
Bestguarder Amazon store