Owner manual

290
INTELLIGENT ACTUATOR
Appendix
Appendix
I/O Parameters
No. Parameter name
Default value
(Reference)
Input range Unit Remarks
127 Network attribute 8 5050214H 0H to
FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 7: CONNECT_TIMEOUT
(Change is prohibited)
(Setting of “0” is prohibited) (sec)
Bits 8 to 15: Connection retry interval
(IAI protocol B/TCP) (sec)
Bits 16 to 23: Send timeout value (sec)
Bits 24 to 31: IAI protocol B-SIO non-communication
check timer setting (sec)
(IAI protocol B/TCP connection trigger)
128 Network attribute 9 0 0H to
FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 15: SEL server open timeout value (sec)
(No timeout check when “0” is set)
129 Network attribute 10 0 0H to
FFFFFFFFH
Ethernet operation requirement
Bits 0 to 3: Modbus/TCP (Remote I/O)
(0: Not in use
1: Use (Disable EXCEPTION status)
2: Use (Enable EXCEPTION status (upper
two digits of error number))
* Refer to the explanation of error levels in
the operation manual and perform
processing appropriate for each error level.
Bits 4 to 7: TCP/IP message communication
(0: Not in use, 1: Use)
Bits 8 to 31: Reserved (Operation requirement)
130 Own MAC address (H) 0H Reference only
(HEX)
Only lower two bytes are valid.
131 Own MAC address (L) 0H Reference only
(HEX)
132 Own IP address (H) 192 1 to 255 * Setting of “0” and “127” is prohibited.
133 Own IP address (MH) 168 0 to 255
134 Own IP address (ML) 0 0 to 255
135 Own IP address (L) 1 1 to 254 * Setting of “0” and “255” is prohibited.
136 Subnet mask (H) 255 0 to 255
137 Subnet mask (MH) 255 0 to 255
138 Subnet mask (ML) 255 0 to 255
139 Subnet mask (L) 0 0 to 255
140 Default gateway (H) 0 0 to 255
141 Default gateway (MH) 0 0 to 255
142 Default gateway (ML) 0 0 to 255
143 Default gateway (L) 0 0 to 255
144 IAI protocol B/TCP:
Own port number
(MANU mode)
64511 1025 to 65535
145 Channel 31 opened to
user (TCP/IP): Own
port number
64512 1025 to 65535
146 Channel 32 opened to
user (TCP/IP): Own
port number
64513 1025 to 65535
147 Channel 33 opened to
user (TCP/IP): Own
port number
64514 1025 to 65535
148 Channel 34 opened to
user (TCP/IP): Own
port number
64515 1025 to 65535
* Important note: Always set a unique number for each port
number.
(Duplication of port numbers is permitted only in the IAI
protocol B/TCP MANU/AUTO modes.)
149 IAI protocol B/TCP: IP
address of connection
destination (MANU
mode) (H)
192 0 to 255 * Setting of “0” and “127” is prohibited.