Owner's manual

10. Position Edit
136
(5) Incorporation of current positions as data
Check the work coordinate system No., tool coordinate system No., and arm system currently
selected in advance. (Mode flow:
, X-SEL-PX/QX is
(GLW3RVL7FK6±&UG
7KHVHOHFWHGDFWXDWRU¶VORFDWLRQLVLQFRUSRUDWHGDVSRVLWLRQGDWDonto the teaching screen.
(DFKD[LVGDWDLQSXWVFUHHQ
(QWHUWKHSRVLWLRQ1RLQWRZKLFKGDWDLVLQFRUSRUDWHG
ZLWKWKHNH\RQWKHSRVLtion No. selection screen,
DQGSUHVVWKHUHWXUQNH\
2U VHOHFW WKH SRVLWLRQ 1R LQWR ZKLFK GDWD LV
LQFRUSRUDWHG ZLWK WKH 3$*( 83 DQG 3$*( '2:1
NH\VRQWKHGDWDLQSXWVFUHHQ
(DFKD[LVGDWDLQSXWVFUHHQ
2Q WKH SRVLWLRQ 1R VHOHFWLRQ VFUHHQ SUHVVLQJ WKH
)6FDQNH\LQFRUSRUDWHVWKHFXUUHQWSRVLWLRQGDWD
for all axes.
2QWKH D[LVVSHFLILF GDWDLQSXW VFUHHQ SUHVVLQJWKH
)6FDQNH\LQFRUSRUDWHVWKHFXUUHQWSRVLWLRQGDWD
of the axis over which the cursor is located. (The
GDWDLVLQFRUSRUDWHGRQDQD[LVEDVLV7KHOHIWILJXUH
LQGLFDWHV WKH FDVH RI GDWD LQFRUSRUDWLRQ RQ WKH
D[LVVSHFLILFGDWDLQSXWVFUHHQ
,QFDVHRI;6(/3;4;5;6;5;'6;'(GLW3RVL7FK6&UG
In the case of the XSEL-RX/SX or RXD/SXD controller, it can be selected as to whether or not
the arm system is scanned and the data is set on the position data.
Only for XSEL-RXD/SXD, Axis 5 to 8 Arm System Scanning Selection Item is displayed.
In the case of the XSEL-RXD/SXD Controller, pressing the or key changes the cursor
position from “Arm(Axis 1 - 4)” to “Arm (Axis 5 - 8)” and again to “Arm (Axis 1-4), in this
order. Select the SCARA Axis to be setup.
When the or key is pressed, the setting is changed from ON -> OFF -> ON in this
order.
21 :KHQVHOHFWHGWKHDUPV\VWHPGDWDLVVFDQQHG
2)) :KHQVHOHFWHGWKHDUPV\VWHPGDWDLVQRWVFDQQHG
Ԙ
ԙ
Arm System Data for Axes No. 1 to 4 Scanning Selection
Arm System Data for Axes No. 5 to 8 Scanning Selection
Function key display section