Owner's manual

7. Simple Operation Procedure

Select the F1 (Edit) key on the Mode Selection

screen.

Select the F2 (Prog) key on the Edit mode screen.

Select the F1 (Mdfy) key on the Edit-Prog (program

edit and new creation) screen.

The screen changes to the program No. input mode

screen. The cursor is located at the program No.

Press the return key to move the cursor to the

location of the step No.

 :KHQ WKH SURJUDP¶V GDWD LV DOUHDG\ LQSXW

overwrite it (the original data is lost) or select the

program No. with no data input. The program No. or

step No. over which the cursor is located can be

changed with the PAGE UP and PAGE DOWN keys.

,Q DGGLWLRQ SUHVVLQJ WKH UHWXUQ NH\ DIWHULQSXWWLQJ D

numerical value with the 10 key can change the

program No. or step No.

$OVR \RX FDQ FKDQJH WKH SURJUDP 1R E\ SUHVVLQJ

the return key after the 10 key input. If the return key

LV SUHVVHG WKH FXUVRU will move to the step No.

7KHQ WKH SURJUDP 1R FDQ EH FKDQJHG ZLWK WKH

PAGE UP 䊶PAGE DOWN keys.

You can also input it directly by using the 10 keys.

Program No.

Step No.

The number of steps saved in the

controller at the specific program.