Manual

4. Position Table Settings

(8) Zone +/–

• This field defines the range within which the zone output signal turns ON during operation of the

standard type.

To increase flexibility, a different range can be set for each target position.

[Setting example]

(9) Acceleration/

deceleration

mode

• This field is not used with this controller.

The factory setting is “0.”

(10) Incremental

• This field defines whether to use the absolute mode or incremental mode.

The factory setting is “0.”

0: Absolute mode

1: Incremental mode

Warning: When using the proximity switch type, be sure to specify the absolute mode. If the incremental mode is

specified, a position data error will occur.

(11) Command mode

• This field is not used with this controller.

The factory setting is “0.”

Position Zone + Zone – Comment

[mm] [mm] [mm]

Rear end

Front end

Intermediate point

Move command to the rear end

Move command to the front end

Move command to the

intermediate point

Zone output signal

Rear end

Front end

Intermediate

point

Home

+ side limit