Owner manual

4. Maintenance inspection
72
[2] When Acquiring Stopper Pressing Position on Each Axis One by One
To have an acquirement on each axis, follow the steps below.
(1) 1
st
Arm and 2
nd
Arm
1) Select “Individual axis” in the Push stopper position acquisition window, and set Axis to
“Arm 1” (or Arm 2).
2) In case there is a concern that a load may interfere with surroundings at the absolute reset,
detach the load. Have the work during the emergency stop condition. After the work is
finished, click on the “OK” button.