Owner manual

71
12. Motor Replacement Procedures
(12) Installing the rear cover
x Affix the ground wire using the cap screw.
<List of ground wires, affixing bolts and tightening torques> N-cm {kgm-cm}
Type Nominal diameter
Length
(mm)
Torque Quantity
IS(P)DA-S
M3 5 83.0 {8.47} 1
IS(P)DA-M
M2.6 8 34.5 {3.52}
1
IS(P)DA-L
M2.6 8 34.5 {3.52}
1
IS(P)DACR-S
M3 5 88.7 {9.05}
1
x Store the wires below the motor so that the M connector and PG connector are no longer seen.
x Affix the ground wire, and then affix the rear cover using the four bolts.
<List of rear cover affixing bolts and tightening torques> N-cm {kgm-cm}
Type Nominal diameter
Length
(mm)
Torque Quantity
ISDA-S
M4 12 176 {18.0} 4
ISDA-M
M5 12 342 {34.9}
4
ISDA-L
M6 15 536 {54.7}
4
ISDACR-S
M4 12 207 {21.1}
4
ISDACR-M
M5 12 411 {41.9}
4
ISDACR-L
M6 15 644 {65.7}
4
ISDA (CR)-S
ISDA (CR)-M, L