Manual

70
[Function] This command moves the actuator through the position data of the designated axis pattern.
(Even if there is data in axes other than those designated, the actuator will not move to these positions).
[Example] GRP 00000011 From position data for 8 axes, data from axis 1 and 2 is taken out and executed.
[Function] This command sets up the motion increments for use with CIR (Circular Movement) and ARC
(Arc Movement) commands. When performing CIR and ARC commands, passing points will be calculated
by dividing a circle into the degrees as set. When increments are set small, the circular movement is
accurate, however, when they are too small, the speed becomes too slow. When CIR and ARC commands are
performed without setting increments, the motion increments of the actuator will be 15 degrees.
[Example] DEG 10
Motion in 10
degree increments.
noisnapxE
noitidnoc
·DNA(
)RO
tupnI
noitidnoc
)galF·O/I(
dnammoC
tsoP
·troptuptuO(
)galF
dnammoC 1dnarepO 2dnarepO
lanoitpOlanoitpOPRG
sixA
nrettap
noisnapxE
noitidnoc
·DNA(
)RO
tupnI
noitidnoc
)galF·O/I(
dnammoC
tsoP
·troptuptuO(
)galF
dnammoC 1dnarepO 2dnarepO
lanoitpOlanoitpOGEDelgnA
12. SEL Language
●GRP (Grouping of Axes)
●DEG (Degree Setting)