Manual

64
● OVRD (Override)
[Function] This command decreases the velocity according to the designated ratio. (Velocity coefficient setting).
The range of the ratio settings is from 1 ~100%.
*When you use the override function, any value below 1 will be clamped at 1. Any decimal value in the
speed setting will be rounded off.
[Example] VEL 100 100mm/sec setting.
OVRD 50 100mm/sec is reduced by 50% and the actual velocity becomes 50mm/sec.
noisnapxE
noitidnoc
)RO·DNA(
tupnI
noitidnoc
)galF·O/I(
dnammoC
tsoP
)galF·troptuptuO(
dnammoC 1dnarepO 2dnarepO
lanoitpOlanoitpODRVO
yticoleV
eulavoitar
The velocity between these two points is 1000mm/sec.
The velocity between these two points is 500mm/sec.
[Function] Sets the velocity of an actuator movement in mm/sec. The maximum velocity varies according to the model
of the actuator so please set below that value.
*Decimal places cannot be used. Entering a decimal value will cause an error.
*The minimum velocity setting is 1mm/sec.
[Example] VEL 1000
1000mm/sec (Velocity Setting)
VEL1000
MOVP 1
MOVP 2
VEL 5 00
MOVP 3
MOVP 4
noisnapxE
noitidnoc
)RO·DNA(
tupnI
noitidnoc
)galF·O/I(
dnammoC
tsoP
)galF·troptuptuO(
dnammoC 1dnarepO 2dnarepO
lanoitpOlanoitpOLEVyticoleV
12. SEL Language
● VEL(Velocity)