Manual

62
12. SEL Language
● PVEL (Assign Velocity Data)
[Function] Assigns the value in operand 1 as the velocity for the designated position data. Variables can also be
used. This command is used to change the actual velocity.
* When a value is assigned that will result in a negative number after calculation, there is no warning at
the time you execute this command but an alarm will occur when you try to use the data.
[Example] PVEL 100 3 Assign a value of 100mm/sec to the velocity data for position number 3.
noisnapxE
noitidnoc
)RO·DNA(
tupnI
noitidnoc
)galF·O/I(
dnammoC
tsoP
)galF·troptuptuO(
dnammoC 1dnarepO 2dnarepO
lanoitpOlanoitpOLEVPyticoleV.oNnoitisoP
[Function] Assigns the acceleration data in Operand 1 for the acceleration of the position data. As with the PVEL
command, you can assign a value using the variable but there is no function that checks the value range
when executing this command. Therefore, please be careful not to assign a value that exceeds the actuator's
limits.
[Example] PACC 0.3 3 Assign a value of 0.3 to the acceleration speed data for position number 3.
noisnapxE
noitidnoc
)RO·DNA(
tupnI
noitidnoc
)galF·O/I(
dnammoC
tsoP
)galF·troptuptuO(
dnammoC 1dnarepO 2dnarepO
lanoitpOlanoitpOCCAPnoitareleccA.oNnoitisoP
● PACC (Assign Acceleration Data)