Owner's manual

50
5. Operation of CON Controllers
No. Operation Screen Remarks
7 Next, touch the velocity of
position No. 0.
8 When the numerical keypad
appears, touch [3], [0], [0] and
then touch [ENT].
9 Next, touch the target position
of position No. 1.
When the numerical keypad
appears, touch [2], [5], [0] and
then touch [ENT].
To reenter the value, touch
[ESC].
10 When registering a new position
data, the default values set by
user parameters are
automatically entered for the
velocity, acceleration,
deceleration, etc.
In this example, the default
value is 100 mm/s.
11 Next, touch the velocity of
position No. 1.
12 When the numerical keypad
appears, touch [3], [0], [0] and
then touch [ENT].