Manualshelf

Owner's manual

ManualsBrandsIAI America ManualsHardwareASEL
451452453454455456457458459460
Appendix Error List (MAIN application) (In the panel window, the
three digits after “E” indicate an error number.)
433
Appendix
(In the panel window, the three digits after “E” indicate an error number.)
Error No. Error name Description, action, etc.
E7F Stroke parameter error Check axis-specific parameter Nos. 7, 8, 1, etc.
E80 Unsupported card error An unsupported card is installed in an I/O slot.
E81 Priority auto-assignment card non-detection error Priority auto-assignment card cannot be detected.
E82 Card mismatch error The combination or positioning of I/O slot cards has a problem.
E83 I/O slot card error The I/O slot card is invalid.
E84 Resolution parameter error Check axis-specific parameter Nos. 47, 50, 51, 44, 42, 43, 1, 37, etc.
E85 Driver ready OFF factor indeterminable error Driver ready OFF factor cannot be determined.
E86 Fieldbus error (FBVCCER) A fieldbus error (FBVCCER) was detected.
E87 Fieldbus error (FBPOWER) A fieldbus error (FBPOWER) was detected.
E88 Power error (Other) A power error (Other) was detected. This error also generates when the power
OFF o ON interval is short. After the power has been turned off, be sure to wait
for at least 5 seconds before turning it back on. Abnormal regenerative resistance
temperature is also suspected.
E89 SCIF open error in non-AUTO mode (Servo in use) In a mode other than AUTO, opening of the serial 1 channel (also used by the PC
software/TP port) from a SEL program is prohibited while the servo is in use (to
ensure safety).
E8A SEL program flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.
E8B Symbol definition table flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.
E8C Point data flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.
E8D Parameter flash-ROM status error Data is not written to the flash ROM correctly or written in an old, incompatible
application version.