User's Manual

Mounting

IAD18001 is MIS-D75 compatible, the recommended screw is M4 x 4.5~5mm (excl. bracket thickness)

Mounting Option 1: [VESA mount]

Supporting VESA standard: VESA MIS-D75 (75*75mm)

Supporting screw: M4*4mm (exclude the mounting plate thickness)

Mounting Option 2: [Using back cover]

(power / SD card brackets MUST NOT installed while mount on back cover)

Release the back cover screw to release back cover

Install back cover : thread head height must not exceed 3mm

Route power and network cable from bottom as shown in photo

Plug power and network cable to signboard , and then install signboard with back cover carefully

1.4. System setup

INSTALL the AC power adapter

→ You should see the player boot up screen as shown in right

WAIT while player boots up

→ once you see “Basic settings” on screen, the unit is ready for content

update or menu configuration

PLUG IN a USB mouse to the unit’s USB port or configure by touch

screen(IAD18001 only)

Enter the corresponding configuration option by moving the mouse cursor over the configuration and click

on the option to enter (or tap on the configuration option for IAD18001)

→ find and set the correct time/date AND time zone.

IMPORTANT: time zone must be set correctly in the menu or via management software for scheduled playback

→ (OPTIONAL) Set a Password in the menus to prevent unauthorized changes.

IMPORTANT: Password will be asked while enter the setup menu during playback

Click Set content button to configure your signage appliance to the content service if needed

→ For advanced player configuration, such as static IP, display resolution, and firmware update, visit