User's Manual

www.tuv.com
Test Report No.: 14011226 001 Appendix 4 Page 24 of 35
(Page 7)
Pairing Your Headset
1. Place the headset and the mobile phone where they are no more than one metre apart.
2. Ensure the headset is off. (The LED indicator does not flash.)
3. Press and hold the MFB until the headset’s LED indicator flashes blue and red alternately.
4. Activate your mobile phone’s Bluetooth function. Please refer to your mobile phone user guide for details.
5. Set the mobile phone to search for Bluetooth devices within the one metre range, as instructed in the mobile
phone user guide, and select “i.Tech Clip IIe” from the list.
6. Enter the pre-programmed passkey “0000” and press “OK” to pair your headset and mobile phone. When
the pairing is completed, the headset’s LED indicator will flash blue rapidly for five times followed by a long
beep.
7. Go back to your mobile phone’s main menu. For certain mobile phone models, once the headset is
activated, a headset icon will be shown on the screen. You should now be able to make and receive calls
using your headset.
IMPORTANT: If the pairing cannot be completed within two minutes after the pairing mode has been
activated, the headset’s LED indicator will flash purple-red with three beeps, the headset will then turn
off automatically. Please repeat step 2 to 7 above to pair the headset and the mobile phone again.