Network Device User's Guide

6-5

Operation

6.2.2. Switching Outlets - Text Interface

To switch or default outlets, or initiate a Boot Cycle, proceed as follows:

1. Switch Outlet(s) On: To power-on an outlet, type /ON n and press

[Enter]. Where "

n" is the number or name of the desired outlet.

For example:

/ON 1 or /ON ROUTER

2. Switch Outlet(s) Off: To power-off an outlet, type /OFF n and press

[Enter]. Where "n" is the number or name of the desired outlet. Note

that the "/OFF" command can also be entered as "/OF". For example:

/OFF 2 or /OF ROUTER

3. Boot Outlets(s): To initiate a Boot cycle, type /BOOT n and press

[Enter]. Where "n" is a the number or name of the desired outlet. Note

that the "/BOOT" command can also be entered as "/BO". For example:

/BOOT 1 or /BO ATMSWTCH

4. Set Outlets to Power Up Defaults: Type /DPL and press [Enter]. All

outlets will be set to their default On/Off status, which is deﬁned using the

Plug Parameters Menu as described in Section 5.5.5.

5. Suppress Command Conﬁrmation Prompt: To execute a Boot/On/Off

command without displaying the "Sure?" prompt, include the ",Y" option

at the end of the command line. For example:

/ON,Y ROUTER or /BOOT,Y 2