Datasheet

Note:

On the GLAN port set the communication properties as follows (right mouse button-

Properties): in the Advanced tab set the corresponding parameters for Ethernet

communication.

FAQ

Question: After connecting the network cable there is no communication?

Answer: Check if the connector of the connected cable is pushed all the way down

and check the cabling.

Question: All is working, but the indicated speed is only 100 Mbps or 10 Mbps,

where is the problem?

Answer: Check all cabling between the PC and the active network component and

push down connectors RJ-45. Changing the Ethernet cable between the adaptor

and active network component (HUB, switch, router) for a certified one can also

help.

Quick Start