User's Manual

www.i-sens.com

Replacing the Batteries

Step 1

Make sure the meter is turned off. Push the

cover in the direction of the arrow to open the

battery compartment.

Step 2

Replace the old batteries with new batteries.

Remove the old battery by lifting the battery

with the index finger and pulling out the battery

with your thumb and index fingers as shown in

the figure on the right one by one. Insert two

new batteries with the + side facing up and

make sure the battery is inserted firmly.

Step 3

Place the cover on the battery compartment.

Push down until you hear the tab click into

place.

The CareSens LINK meter comes with two 1.5 V AAA alkaline batteries.

Around 50 tests can still be carried out after the icon appears on the

display for the first time, but the battery should be replaced as soon as

possible.

The test results might not be saved if the battery runs out.

Removing the meter batteries will not affect your stored result.

However, you may need to re-set your meter settings. See pages

12 ~ 14.

Note

Bluetooth Paring

When the meter is off, hold the 󱈼 buttons for 2 seconds to pair the

meter and the other Bluetooth device. ‘bT’ will be blinked on the

display, and the Bluetooth connection will be available.

Depending on the user’s Bluetooth settings PIN Code input may be

necessary in order to register the external Bluetooth device. In this

case, type in ‘0000’ in the input box.

When the measured glucose value has been transmitted via

Bluetooth, the transmitted data in the meter will be automatically

deleted and the meter will turn itself off.

Blinking ‘bT’ on the display means that the search of the Bluetooth

device is available. The meter will be automatically turned off

after entering the mode. If the meter is turned off before finishing

Bluetooth paring, retry the paring by holding the 󱈼 button.

Note