User's Manual

38 39
CHARGING MENDOR SMART BLOOD GLUCOSE METER
When the meter starts charging, the battery icon and its status will be displayed
on the screen as shown on the previous page.
Caution:
• Only use provided Micro USB cable.
• Do not charge the meter in high humidity or in a wet area.
• Do not use the Micro USB cable if it is damaged, abnormally hot or discolored.
• Do not allow children to charge the meter.
• Do not insert Test strip while the meter is charging.
• Before charging the meter, check that the supply voltage is correct.
• When charging the meter, plug the equipment into a supply outlet which has an
earth connection.
• Do not place the equipment in liquid, nor put it where it could fall into liquid. If
the equipment becomes wet, unplug it before touching it.
• Do not leave the equipment unattended for long periods of time while it is
plugged in.
• While charging the meter, do not place anything on top of the equipment.
• DANGER – Misuse of electrical equipment can cause electrocution, burns, re
and other HAZARDS.
ERROR MESSAGES
If error occurs while using the meter, the error screen is displayed and the me-
ter provides a quick solution for resolving the problem.
Error 1
Cause
Cause
Cause
Used test strip
The sample has been applied
before the blood symbol appeared.
Repeat the test with a new test
strip.
Repeat the test with a new test
strip and wait until the blood
symbol appears.
Solution
Solution
Solution
Error 2
Error 3
The temperature during the test was
above or below the operating range.
Move to an area where the tem-
perature is within the operating
range (5 - 50 °C / 41-122 °F) and
repeat the test after 30 minutes.