User manual

i.safe MOBILE
English
6
· Please power off the phone and disconnect the charging cable before
cleaning the phone.
· Do not use any chemical cleaning agents to clean the phone or the
charger. Use a damp and an-stac so cloth for cleaning.
· Do not discard old and abandoned lithium baeries into the trash, send
them to designated waste disposal locaons or return them to i.safe
MOBILE GmbH.
· The user alone is responsible for any and all damages and liabilies caused
by malware downloaded when using the network or other data-exchange
funcons of the phone. i.safe MOBILE GmbH cannot be held responsible
for any of those claims.
Warning
i.safe MOBILE GmbH will not assume any liability for damages caused by
disregarding any of these advices or by any inappropriate use of the phone.
Maintenance / Repair
Thank you for using the CHALLENGER 2.0. If there is a problem with the
phone, please contact your vendor or consult the service center. If your
phone is in need of repair, you can either contact the service center or your
vendor.
Baery
The baery is inserted into the back of the phone. The baery is not fully
charged when the phone is purchased, but it contains enough energy to
power on the phone. To obtain best baery performance and baery life, let
the baery discharge completely before charging it completely for the first
three charging cycles.
Installing the Baery
Turn the mobile phone upside down, open the screws and remove the bat-
tery cover. Install the baery by inserting the teeth at the top of the baery
into the corresponding notches of the phone.
When installing the baery cover, insert the teeth at the boom of the cover
into the corresponding notches of the mobile phone, then press the baery
cover down and secure it by turning the two screws. Ensure that the baery
is safely in place before installing the baery cover and powering on the
phone.