Datasheet

2 - 60
To switch directly to the IRISPen application, you can right-click or double-
click the status window. The status window does more than provide information,
it also gives you direct access to the IRISPen application!
Finally, you can define a hotkey with the command "Hotkeys" under the "Set-
tings" menu. Enter a key combination to restore the application. Evidently, you
should not use key combinations such as Ctrl+V which are used by your target
application(s).
So, restoring the IRISPen application which normally runs in the back-
ground is a cinch. Another interesting feature is that you can switch between the
reading modes with equal comfort. The command "Hotkeys" under the "Settings"
menu again offers the solution.
3chapter2.p65 2/16/2001, 3:23 PM60