User guide
Table Of Contents
- Introducing the IRISPen
- Installation
- Starting up
- Basic settings
- Frequent commands
- Learn how to...
- Customize/save/reopen settings
- Read dot matrix text
- Read small print
- Read numeric data
- Read handprinting
- Read barcodes
- Scan multiple lines
- Scan from right to left
- Scan negative images
- Scan vertical text (optional)
- Define the symbol for unknown characters
- Replace a character string
- Replace vertical lines
- Program hotkeys
- How to get product support?
- How to register?
IRISPen Executive 6 - User's guide
38
Clipboard
If the option Clipboard is selected, the software will send the read
data to the clipboard before you can paste it into the target
application. You will then use the Paste or CTRL+V command to
actually paste the data.
Select this option if you want to manually paste the read data into
your target application.
! Remember that the clipboard can only contain the data of the last
scan.
Active application
This option is selected by default. The recognized data will be
directly inserted at the cursor position in the target application.
Paste mode
If you select Paste mode, the recognized data is first sent to the
clipboard, then automatically inserted at the cursor position in the
target application. This operation is totally transparent for the user.
You should not normally use this option. However, if you notice that
the characters inserted in the target application do not correspond to
the ones actually recognized by the software (see: Starting up, The
Scan Test window), enable it.